Cervis TM70 Manual de instalación descargar pdf (Pagina 74)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

22.0 A1P4RCAN Option

The A1P4RCAN CAN expansion module proves four (4) relay outputs and an analog output.

The analog output simulates a digital potentiometer with 64-steps of the power supply per each

half axis. See the diagram block below (size ½ of LR72):

Figure 44. A1P4RCAN Expansion Module Block Diagram

This CAN expansion provides ser the following outputs:

• A Galvanically isolated analog output that simulates a 128-step digital potentiometer

• four relay outputs; K1, K2, K3 and K4.

These outputs with their addresses written to CANopen frames are CAN Bus controlled. The

CAN address for the card is set using the 7-jumper P1 connector. The jumper in position 1

corresponds with the first bit of the CAN address. In this way, using several jumpers it is possible

to select addresses ranging from 1 to 127 (2

CAUTION

Address 0 is not a valid address, so the board must always be fitted

with at least one jumper. With one jumper, it is possible to configure

seven (7) different addresses.

VOUT

GND

11k2

-V

CAN

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 102 103

Sin comentarios

Cervis TM70 Manual de instalación Pagina 74