Cervis TM70 Manual de instalación descargar pdf (Pagina 28)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

11.0 Program the Machine ID in LCD Transmitters

Transmitters with an LCD display allow the operator to program a machine identification label of

up to 24 text characters that is displayed upon start up. The programmed text should be carefully

chosen to allow for immediate identification of the machine for which it is intended to control.

The ID text can be entered using the following steps.

1. Use the Technical Data Sheet supplied with your system to identify the following functions

• Configuration

• Enter

• Up

• Down, and

• ESC

2. Place a charged battery in the transmitter and turn the ON/OFF key to ON.

3. Push and relese the STOP button. The LED will pulse ORANGE-GREEN.

4. Press and hold both the Configuration and START buttons. Hold for 2-seconds following

which you will enter into CONFIG mode.

5. Press ENTER to get to Menu.

6. Use the UP and DOWN buttons to navigate the menu to EDIT LABEL. Press ENTER.

7. The display will show CRANE ??; the first 3-characters will be blinking. You can edit the

machine name from here by using the DOWN, UP, ENTER, and ESCAPE:

Table 6. Character Entry Reference

Key

Instruction

DOWN

Use to move through the available list characters in descending order.

Use to move through the available list characters in ascending order.

ESC

Use to return to the previous character

ENTER

Use to validate the chosen character and to move to the next character

selection to the immediate right.

8. Push START to store the edited text. The LCD will display SAVED for 2-seconds.

9. Exit Editing Mode by press the STOP button.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 102 103

Sin comentarios

Cervis TM70 Manual de instalación Pagina 28