Cervis TM70 Manual de instalación descargar pdf (Pagina 62)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

17.1 Single Master Transmitter Systems

Figure 31. Single Master Transmitter System

The Master Transmitter crane selector has options 1/1+2/2.The Slave Transmitter only has an R

release pushbutton.

When Tandem Operation Is Needed (Figure 31)

1. The operator of the Master Transmitter must have the Slave Transmitter operator RELEASE

Receiver 1. To release, the R pushbutton and the START button must by simultaneously

pressed. Transmitter 1 commands Receiver 1 to disconnect and ready itself to accept a new

ID code.

2. The operator of the Master Transmitter then selects Switch Position 1+2.

3. The operator of the Master Transmitter must press and hold the START button until the

Green LED switches ON. This commands Receiver 2 to release Receiver 2, and then new ID

codes are sent to both Receiver 1 and Receiver 2.

Both receivers 1 and 2 are then started, ready for tandem operation.

When Tandem Operation Is Finished

When tandem operation has finished, the Master Transmitter must select Switch Position 2

again (in our example above) and press the Start button. Receiver 1 is release again ready to be

used by the Slave Transmitter, and the Master Transmitter then only controls Receiver 2.



Note: To reconnect Transmitter 1 to Receiver 1 in our example above, the operator must first

cycle the transmitter — power it OFF and then ON — and then press the START button

while the selector switch in set to 1.

ID1

ID2

ID1

ID2

SLAVE

RECEIVER 1

RECEIVER 2

MASTER

SLAVE

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 102 103

Sin comentarios

Cervis TM70 Manual de instalación Pagina 62