Cervis TM70 Manual de instalación descargar pdf (Pagina 64)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

18.0 TM70 Analog Feedback Calibration

Analog feedback systems must have the Display and Analog Feedback options. The analog

input must be calibrated upon startup. Transmitters with the display option allow the operator to

calibrate the analog input using the display three digit value and a comma; and, a measurement

unit of up to three characters.



Note: Calibration generates a linear interpolation of the possible values. This means that it

can be used with all systems that generate a linear analog output. For non-linear systems,

the interpolation will display an incorrect value.

Analog Feedback Calibration Using the LCD Display



Note: Feedback calibration modified in the transmitter are not updated in the receiver

EEPROM. The information must be copied from the transmitter EEPROM to the receiver

memory.

1. Insert a fully charged battery into the transmitter and turn the Key Switch to ON.

2. Push and then pull-out the STOP button.

3. Place a known load on the crane to introduce the first value.

4. Turn off the remote control and start the system in CALIBRATION mode as follows:

Press and hold the LCD70 ENTER button, then press and hold the TM70 START button.

Hold both until CONFIG option appears on the display.

5. Press the ENTER button to get into MENU. Use the UP and DOWN arrows on the display to

navigate the MENU.

6. Use the UP and Down buttons to find CAL. (Calibration). Press ENTER to gain the

Calibration submenu.

7. Use the UP and DOWN buttons to navigate through the Calibration submenu. You will find

Value 1, Value 2, and UNITS.

8. Navigate to the desired submenu, Value 1, and press ENTER to enter that submenu. Note

that the receiver will start up, but you will not have control over crane motion. The transmitter

must communicate with the receiver in order for the information from the analog input to be

sent to the transmitter.

While in a submenu (Value 1, Value 2, or UNITS), you can use the Display Keys in the following

manner:

• The DOWN Key moves through the character list in descending order. A to B for instance.

• The UP Key moves through the character list in ascending order. B to A for instance.

• The ESC Key is used to return to the previously stored character.

• The ENTER Key is used to select the chosen character for that digit position and move to

the next digit position.

9. Once a corresponding value is assigned to the suspended load, the display will show three

digits plus a comma. Make sure the value displayed is accurate.

10. Press the START Button to Save the displayed value. The value will be memorized

for that calibration item. Communication with the receiver will stop.

11. Press ESC to return to the previous menu to edit the Units. Units can be no more

than three (3) characters.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 102 103

Comentarios a estos manuales

Sin comentarios

Cervis TM70 Manual de instalación Pagina 64

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos Cervis TM70