Cervis TM70 Manual de instalación descargar pdf (Pagina 27)

Operation and Installation Manual

2013 Cervis, Inc.

10. Press and hold the switch identified as “COPY EP” and the START button at the same

time (Figure 10). The LED blinks RED.

11. Continue to hold the both until the LED blinks ORANGE and then release both buttons.

The LED will light GREEN. LCD display models will display “Reading…” and then

“Reading ok Chang EEP”.



Note: In the event that the LED remains lit RED, or the LCD displays “Reading nok”, you will

have to repeat the process.

12. When the copying process is complete, remove the Master EP70 and replace it with a

blank EEPROM.

13. Move the switch to COPY EP (



). The LED will flash ORANGE indicating that the copied

memory is being written to the blank EP70. An LCD display will indicated “Writing..” and

then “Writing ok”. If the LED remains RED, or the LCD displays “Writing nok”, repeat the

process.

14. When complete, press the STOP button. This completes the programming process.

Reassemble the console box.

Figure 10. Copy EP

START

Copy EEPROM

LED

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 102 103

Sin comentarios

Cervis TM70 Manual de instalación Pagina 27