Cervis TM70 Manual de instalación descargar pdf (Pagina 18)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

5.0 Starting Up

Proceed with caution upon initial Startup! Disconnect the power

supply from the motors before applying power to the Receiver to

prevent unintended movement of the equipment in case of

improper connections.

1. Once the receiver has been connected, disconnect the power supply to the

motors—by removing the fuses for example—and then power up the receiver.

The receiver enters into a SCANNING mode upon power-up; the receiver LED

power-up states are defined in Table 2.

Table 2. Receiver LED States During Power-Up

LED

State

Indication

POWER (1) ON

Power supply is correct

HARDOK (2) ON

Absence of faults on the boards

SIGNAL (3)

OFF

Blinks

Channels are signal free

An RF signal on the channels

DATA (4)

OFF

Blinks

Another TM70 system is not active in the area

Another TM70 system is active in the area

ID (5) OFF

System Transmitter not on.

CAN_RUN (6) ON

Indicates that CAN communications with expansion

boards are OK.

CAN_ERR (7) OFF

Figure 7. LEDs by Number

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 102 103

Sin comentarios

Cervis TM70 Manual de instalación Pagina 18