Cervis TM70 Manual de instalación descargar pdf (Pagina 66)

TM70Bi V3.1 (03/09) 1121174.pdf

IKUSI reserves the right to change this information without prior notice.

OUTPUT PWM1

The connections of the output 1 are through 4 pole terminal plug, with the follow pin assignment:

Output 1 connector

Pin Name

Function

VPP1

Power of channel 1

GND1

Ground of channel 1

VO1

DIRECT analogue PWM output of channel 1

VR1

INVERSE analogue PWM output of channel 1

OUTPUT PWM2

The connections of the output 1 are through 4 pole terminal plug, with the follow pin assignment:

Output 2 connector

Pin name

Function

VPP2

Power of channel 2

GND2

Ground of channel 2

VO2

DIRECT analogue PWM output of channel 2

VR2

INVERSE analogue PWM output of channel 2

ISP (PROGRAMACION “IN CIRCUIT” / “IN SYSTEM”)

The expansion has a connector to record “In-System” (eg. Microprocessor software update). This connector

has 10 pins:

ISP connector

Pin name

Function

ISP2

Input connected to the ground to place the microcontroller in recording mode

TX2

Not used

RX2

Receiving data signal

GND

Ground

RX1

Receiving data signal

TX1

Transmisión data signal

ISP

Not used

VCC

Power supply output at 3,3 V

MRNOT

Reset input, active when it is connected to ground

+VI

Power supply output at 12 V (not stabilized, can vary between 8 y 22 V)

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 75 76

Comentarios a estos manuales

Sin comentarios

Cervis TM70 Manual de instalación Pagina 66

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos Cervis TM70