Cervis TM70 Manual de instalación descargar pdf (Pagina 45)

TM70Bi V3.1 (03/09) 1121174.pdf

IKUSI reserves the right to change this information without prior notice.

SLAVE

MASTER

13.2 - ONE MASTER TRANSMITTER SYSTEMS

RECEIVER 2

RECEIVER 1

ID2

ID1

ID2

ID1

SLAVE

MASTER

The MASTER transmitter has got a crane selector “1 / 1+2 / 2”, while the SLAVE transmitter has only

got a release “R” push button.

When a TANDEM operation is needed, the operator of the MASTER transmitter must need that the

SLAVE transmitter operator must release the RECEIVER 2. In order to do it, it has to be pressed

simultaneously the release “R” push button and the START button. The transmitter will send to the

RECEIVER 2 the liberation order, remaining disconnected and ready to accept a new ID code.

At this stage, the position “1+2” may be selected in the MASTER transmitter and then press the

START button until the Green LED is switched on and it will send the new ID code. Both receivers, 1

and 2, will then be started and ready to TANDEM operation.

When TANDEM operation has finished, the MASTER transmitter must select position 1 again and

press the START button. By doing this, RECEIVER 2 is again ready to be used by the SLAVE

transmitter, and the MAESTRO transmitter only controls RECEIVER 1.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 75 76

Sin comentarios

Cervis TM70 Manual de instalación Pagina 45